TYPE: | |
---|---|
SKU: | |
Availability: | |
Quantity: | |
Product Description
FCC ID | TS008 |
P/N | 37172-57L10 |
Chip | 46 CHIP |
Button | Lock, Unlock |
Frequency | 433MHz |
Battery | CR2032 |
Factory | OEM |
For | 2010-2016 Suzuki Swift 2010-2016 Suzuki Kizashi |
Tips
1. The specific methods of using the keyless entry function of the 2018 Qiyue are as follows:
Keyless entry: Carry the key with you, and there is no need to insert the key into the keyhole. When the key is close to the car body, it will automatically match the car decoder. Put your hand into the left front door handle unlock sensor area, and the four doors will automatically unlock. .
Keyless locking: When the key leaves the car body, the door will automatically lock. At this time, the turn signal flashes once and a short horn sound will be heard, indicating that the door is successfully locked.
Open the trunk: Press the unlock button of the remote control key once, or press and hold the trunk unlock button on the key. If you find that the turn signal flashes 3 times, the trunk has been opened.
2. Mazda 3 Sedan touch sensor failure warning sound (with advanced remote control function), if all of the following conditions are met, activating the warning sound will notify the driver that the door is unlocked:
Turn off the ignition switch.
All doors are not fully closed.
The lock was operated three times within 5 seconds.
Check the ignition switch and check whether the door is opened or closed before operating the lock again.
3. Mazda3 Sedan key left in trunk warning sound (with advanced remote control function), if the key is left in the trunk, all doors are locked, and the trunk lid is closed, a beep will be heard outside the car for about 10 seconds This sound is used to notify the driver that the key is left in the trunk. In this case, open the trunk lid by pressing the electronic trunk lid opener and remove the key. A key taken out of the trunk may not work because its functionality is temporarily stopped. If the functionality of the key is to be restored, the key abort function should be performed.